Tektronix DPO4000 User Manual download pdf (Page 7)

100

101

Getting Started

This manual explains the use of commands for remotely controlling your

oscilloscope. With this information, you can write computer programs to

perform func

tions, such as setting the front-panel controls, taking measurements,

performing statistical calculations, and exporting data for use in other programs.

Setting Up R emote Communications

You can remotely communicate bet ween your oscilloscope and PC via the

Ethernet, USB, and, GPIB using the TEK-USB-488 Adapter.

Ethernet

If you are

using Ethernet, start by connecting an appropriate Ethernet cable to the

Ethernet port (RJ-45 connector) on the rear panel of your oscilloscope. This

connects the oscilloscope to a 10/100 Base-T local area network.

To change the Ethernet settings on your oscilloscope, do the following:

1. On the front panel, push Utility.

2. Push Utility Page.

3. Select I/O with the Multipurpose knob.

4. Push Ethernet Network Settings.

5. On the side-bezel menu, if you are on a DHCP Ethernet network and using a

through cable, set DHCP/BOOTP to On.

6. If you are using a cross-over cable, set DHCP/BOOTP to Off, and set a hard

coded TCPIP address.

USB

If you are using USB, start by connecting an appropriate USB cable to the USB

2.0 high-speed device port on the rear panel of your oscilloscope.

MSO4000 and DPO4000 Series Programmer Manual 1-1

1 2 3 4 5 6 7 8 9 10 11 12 ... 584 585

Comments to this Manuals

No comments

Tektronix DPO4000 User Manual Page 7

Comments to this Manuals

Related products and manuals for Measuring, testing & control Tektronix DPO4000