Tektronix DPO4000 User Manual download pdf (Page 21)

100

101

Command Groups

This manual lists the MSO4000 and DPO4000 Series IEEE488.2 commands

in two ways. First, it presents them by functional groups. Then, it lists them

alphabetica

lly. The functional group list starts below. The alphabetical list

provides detail on each command. (See page 2-69, Commands Listed in

Alphabetical Order.)

Acquisition Command Group

Use the commands in the Acquisition Command Group to set up the modes and

functions that control how the oscilloscope acquires signals input to the channels,

and processes them into waveforms.

Using the commands in this group, you can do the following:

Start and stop acquisitions.

Control whether each waveform is simply acquired, averaged, or enveloped

over successive acquisitions of that waveform.

Set the controls or conditions that start and stop acquisitions.

Contr

ol acquisition of channel waveforms.

Set acquisition parameters.

Tabl

e 2-13: Acquisition Commands

Command Description

ACQuire?

Ret

urns acquisition parameters

ACQuire:MAGnivu Sets or returns the MagniVu feature

ACQuire:MAXSamplerate?

turns the maximum real-time s ample rate

ACQuire:MODe Sets or returns the acquisition mode

ACQuire:NUMACq? Returns number of acquisitions that have

occurred

ACQuire:NUMAVg Sets or returns the number of acquisitions for

an averaged waveform

ACQuire:STATE Starts or stops the acquisition system

ACQuire:STOPAfter Sets or returns whether the acquisition is

continuous or single sequence

MSO4000 and DPO4000 Series Programmer Manual 2-11

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 584 585

Comments to this Manuals

No comments

Tektronix DPO4000 User Manual Page 21

Comments to this Manuals

Related products and manuals for Measuring, testing & control Tektronix DPO4000