Tektronix DPO4000 User Manual Page 58

  • Download
  • Add to my manuals
  • Print
  • Page
    / 585
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 57
Command Groups
Table 2-30: Status and Error Commands (cont.)
Command
Description
EVMsg? Returns event code, message from the event
queue
EVQty? Return number of events in the event queue
*OPC Generates the operation complete message
in the standard event status register when all
pending operations are nished
Or returns "1" when all current operations
are nished
*PSC Sets or returns the power on status ag
*PUD Sets or returns a string of protected user data
*RST Resets the oscilloscope to factory default
settings
*SRE Sets or returns the bits in the Service
Request Enable Register
*STB? Returns the contents of the Status By te
Register
*WAI Prevents the oscilloscope from executing
further commands until all pending
operations nish
Trigger Command G roup
Use the commands in the Trigger Command Group to control all aspects of
triggering for the oscilloscope.
There are two triggers: A and B. Where appropriate, this command set has parallel
construction between triggers.
You c an set the A or B triggers to edge mode. Edge triggering lets you display
a waveform at or near the point where the signal passes through a voltage level
of your choosing.
You can also set A triggers to pulse, logic
, or video modes. With pulse triggering,
the oscilloscope triggers whenever it detects a pulse of a certain width or height.
Logic triggering lets you logically combine the signals on one or channels. The
oscilloscope then triggers when it detects a certain combination of signal levels.
Video triggering e nables you to trigger on the most c ommon Standard Denition
video standards.
Table 2-31: Trigger Commands
Command
Description
TRIGger
Forces a trigger event to
occur
2-48 MSO4000 and DPO4000 Series Programmer Manual
Page view 57
1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 584 585

Comments to this Manuals

No comments